Dr. Hans-Joachim Nikolin, Chairman of the Semperit supervisory board and board member of Continental AG, confirmed during a supervisory board meeting of Semperit Reifen Ges.m.b.H. in Traiskirchen in mid-December that the Semperit factory at Traiskirchen will play an essential strategic part in the introduction of a new manufacturing process. Continental has developed a European strategy for the Modular Manufacturing Process (MMP), envisaging three MMP factories, each responsible for the supply of one large European region. The Traiskirchen factory has been chosen to supply the South and East European markets. The decision about a second MMP location to supply Western Europe is said to be imminent, whereas a suitable supply plant for the North European region has not yet been found. The production plan for the year 2000 gives 1.5 million car tyres made by the standard and one million by the MMP process, a total number of 2.5 million units as originally planned. However, since the manufacturing process of MMP tyres is less complicated than the standard production process, a reduction in the workforce is inevitable and cannot be compensated for by the planned increased output of 825,000 commercial vehicle tyres in the year 2000. The MMP tyre is produced in modules allowing the cost-effective production of smaller lots, and a fast reaction to the requirements of the market. MMP is therefore primarily designed as a means of reacting fast to developments in the replacement markets, and only in exceptional cases would it be considered for original equipment. This production process does away with the necessity to make a large variety of products at the standard factories, thus freeing them for large-series production.